DASL Wiki

1) Take a look at the silicone pieces you just pulled out of the “Glaucus_Left_Bathtub_Bottom” and the “Glaucus_Left_Bathtub_Top” prints. They fit together to form a new mold, one that will produce the waxes you need for the final quadruped. The same goes for the “Right_Bathtub” molds.

2) When your wax is heated, situate the funnel in the mold sprue and pour the melted wax in one continuous stream until the funnel starts to fill up. Leave the funnel in for about thirty seconds, making sure to top it up if the wax level drops below the mold's surface.