User Tools

Site Tools


3._pour_your_waxes

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

3._pour_your_waxes [2016/05/24 12:45] – created yeeunkim3._pour_your_waxes [2016/05/24 12:51] (current) yeeunkim
Line 1: Line 1:
-Take a look at the silicone pieces you just pulled out of the "Glaucus_Left_Bathtub_Bottom" and the "Glaucus_Left_Bathtub_Top" prints. They fit together to form a new mold, one that will produce the waxes you need for the final quadruped. The same goes for the "Right_Bathtub" molds.+1) Take a look at the silicone pieces you just pulled out of the "Glaucus_Left_Bathtub_Bottom" and the "Glaucus_Left_Bathtub_Top" prints. They fit together to form a new mold, one that will produce the waxes you need for the final quadruped. The same goes for the "Right_Bathtub" molds.\\
  
 +2) When your wax is heated, situate the funnel in the mold sprue and pour the melted wax in one continuous stream until the funnel starts to fill up. Leave the funnel in for about thirty seconds, making sure to top it up if the wax level drops below the mold's surface. 
 {{::20160523_194346_hdr.jpg?200 |}} {{::20160523_194346_hdr.jpg?200 |}}
 {{::20160523_194352_hdr.jpg?200 |}} {{::20160523_194352_hdr.jpg?200 |}}
 +
 +
3._pour_your_waxes.txt · Last modified: 2016/05/24 12:51 by yeeunkim