User Tools

Site Tools


haaga_acr_alvaro_work_log

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
haaga_acr_alvaro_work_log [2016/06/17 16:55]
pareshbrahmbhatt
haaga_acr_alvaro_work_log [2016/06/17 16:56] (current)
pareshbrahmbhatt
Line 8: Line 8:
  
 // //
-I was finally able to retrieve info from the Jetson. I first tested with a get partition table command, and it worked, but I could'​t run another command after. It would do the same thing it always does, start, and sit there and do nothing for eternity. I am not sure if the Jetson is setup this way, that after one command it won't take another, and it just becomes a potato because for the most part the only reason you use the USB-B connection to the Jetson is to flash a new OS and then it auto restarts. If you turn it off and reset it Force Recovery Mode you can run a command again, but not two consecutively. I will investigate the manner further. For now, I have used my one command to clone the current APP partition of Jeongmin'​s setup so I have a backup.+I was finally able to retrieve info from the Jetson. I first tested with a "get partition table" ​command, and it worked, but I could'​t run another command after. It would do the same thing it always does, start, and sit there and do nothing for eternity. I am not sure if the Jetson is setup this way, that after one command it won't take another, and it just becomes a potato because for the most part the only reason you use the USB-B connection to the Jetson is to flash a new OS and then it auto restarts. If you turn it off and reset it Force Recovery Mode you can run a command again, but not two consecutively. I will investigate the manner further. For now, I have used my one command to clone the current APP partition of Jeongmin'​s setup so I have a backup.
haaga_acr_alvaro_work_log.txt ยท Last modified: 2016/06/17 16:56 by pareshbrahmbhatt