User Tools

Site Tools


mm-uav_plate-servo_assembly

Plate-Servo Assembly

- Inside of the servo motor box, you can see 2 brackets. Use scissors to cut one of the edge side, then connect them to the servo motor.

- Put drill on each hole on the plate, drill the bigger for the M2*25mm screws.

- Place servomotors on the Bottom plate, put M2*25mm screws from the bottom, then cover them with Nylon unthreaded spacers.

- Put the top plate, then fix it with M3 Nyloc nuts.

mm-uav_plate-servo_assembly.txt · Last modified: 2016/05/04 14:22 by dongbinkim