drexel_duct_navigator_teleop
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
drexel_duct_navigator_teleop [2016/11/07 20:25] – created dwallace | drexel_duct_navigator_teleop [2016/11/07 20:27] (current) – dwallace | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Using a Tele-operating E-Maxx to Remotely Read Radiation Levels ====== | ====== Using a Tele-operating E-Maxx to Remotely Read Radiation Levels ====== | ||
- | This tutorial expands upon the earlier tutorial explaining how to create a [[GUI for tele-operating an E-Maxx for Remote Surveillance using Arduino and Cocoa Development]]. | + | This tutorial expands upon the earlier tutorial explaining how to create a [[drexel_duct_navigator_gui|GUI for tele-operating an E-Maxx for Remote Surveillance using Arduino and Cocoa Development]]. |
{{youtube> | {{youtube> | ||
Line 37: | Line 37: | ||
The Arduino ethernet shield on the Arduino Mega, connected to the router via ethernet cable. | The Arduino ethernet shield on the Arduino Mega, connected to the router via ethernet cable. | ||
- | The geiger counter kit was powered from the Arduino Mega's 5v power supply. A wire connects the geiger counter' | + | The geiger counter kit was powered from the Arduino Mega's 5v power supply. A wire connects the geiger counter' |
{{dylanw: | {{dylanw: |
drexel_duct_navigator_teleop.1478579109.txt.gz · Last modified: 2016/11/07 20:25 by dwallace