drexel_mm_uav_testbed
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
drexel_mm_uav_testbed [2016/11/01 11:09] – created dwallace | drexel_mm_uav_testbed [2016/11/06 03:14] (current) – [Vehicles] dwallace | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Testbed for Aerial Manipulation ====== | ====== Testbed for Aerial Manipulation ====== | ||
- | == Aerial Manipulation Testbed | + | ===== Vehicles |
- | === Vehicles | + | * 3DRobotics |
- | * 3DRobotics [https:// | + | * Asctec Hummingbird |
- | * Asctec Hummingbird | + | * Asctec Pelican |
- | * Asctec Pelican | + | |
- | === Hardware === | + | ===== Hardware |
- | * APM 2.6 Autopilot with Micro-USB cable | + | * APM 2.6 Autopilot with Micro-USB cable |
- | * 12V, 83A [https:// | + | * 12V, 83A [[https:// |
- | ** Notes on tether: The voltage drop across the tether can be problematic. If the quad has a battery voltage sensor, it is recommended to disable that functionality. From the supply, we run a 10-foot section of 10 AWG silicone wire. We then connect another 10 foot section of 12 AWG wire that connects to the quad. If there is no payload, have the tether run down the center of the quad. It will cause slight disturbances while flying. The e-stop should be between the supply and quad. | + | * Notes on tether: The voltage drop across the tether can be problematic. If the quad has a battery voltage sensor, it is recommended to disable that functionality. From the supply, we run a 10-foot section of 10 AWG silicone wire. We then connect another 10 foot section of 12 AWG wire that connects to the quad. If there is no payload, have the tether run down the center of the quad. It will cause slight disturbances while flying. The e-stop should be between the supply and quad. |
- | * [http:// | + | * [[http:// |
- | * 30 feet USB extender | + | * 30 feet USB extender |
- | === Workspace === | + | ===== Workspace |
- | * 7.5 m3 volume | + | * 7.5 m3 volume |
- | * 18 motion capture [http:// | + | * 18 motion capture |
- | === Software === | + | ===== Software |
- | * [https:// | + | * [[https:// |
- | ** [https:// | + | * [[https:// |
drexel_mm_uav_testbed.1478023788.txt.gz · Last modified: 2016/11/01 11:09 by dwallace