mm-uav_plate-servo_assembly
Differences
This shows you the differences between two versions of the page.
mm-uav_plate-servo_assembly [2016/05/04 14:10] – created dongbinkim | mm-uav_plate-servo_assembly [2016/05/04 14:22] (current) – dongbinkim | ||
---|---|---|---|
Line 4: | Line 4: | ||
{{: | {{: | ||
{{: | {{: | ||
+ | |||
+ | - Inside of the servo motor box, you can see 2 brackets. Use scissors to cut one of the edge side, then connect them to the servo motor. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Put drill on each hole on the plate, drill the bigger for the M2*25mm screws. | ||
+ | |||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | - Place servomotors on the Bottom plate, put M2*25mm screws from the bottom, then cover them with Nylon unthreaded spacers. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | - Put the top plate, then fix it with M3 Nyloc nuts. | ||
+ | |||
+ |
mm-uav_plate-servo_assembly.1462396242.txt.gz · Last modified: 2016/05/04 14:10 by dongbinkim