**Making the X axis motor seats**

{{:hotwire01.jpg?200|}}
-Drawing part

{{:20160328_202302.jpg?200|}}
-front side picture

{{:20160328_202309.jpg?200|}}
-back side picture

1. Cut the quadrangle for 6x6inch size x2 and 6x3inch x2

2. Make a whole, 1.4 inch diameter, in the 6x6inch wood to suit for stepper motor!
- the center of the whole's position: center of the width (3 inch by widthwise), 2.3inch of the height
- It must be considered with motor's center

3. assemble the 6x6inch wood and 4x4inch wood to be perpendicular!
- When I screw the 2 structure, It was hard to make it stand perpendicularly, so I screwed the small size square on the both side the structure.