**Making the Y axis motor seats**

0. before making the Y axis motor seats, I found the Y-axis moving square is too high to move a lot. so I take to pieces the machine, and attach the Y-axis moving square to bottom.



1. Cut the 6x3 inch square, and make a whole to the same whole of the X axis motor seats.

2. Attach the square on the stand of the Y-axis.

{{:20160408_214214.jpg?200|}}
{{:20160408_214228.jpg?200|}} -3

3. Attach the stepper motor to each of the seats.

{{:20160412_134719.jpg?200|}}
{{:20160412_185421.jpg?200|}} -4

4. Connect the control board and Power supply. if stepper motor's wire length is short, you can extend the wire with soldering. In my case, I extend the Y-axis stepper motor's wire 50inch and the X-axis's 20 inch.

{{:20160408_214204.jpg?200|}}