**Plate-Servo Assembly**


{{:mmuav_8_.jpg?300|}}
{{:mmuav_9_.jpg?300|}}

- Inside of the servo motor box, you can see 2 brackets. Use scissors to cut one of the edge side, then connect them to the servo motor.

{{:mmuav_10_.jpg?300|}}

- Put drill on each hole on the plate, drill the bigger for the M2*25mm screws.

{{:mmuav_11_.jpg?300|}} 
{{:mmuav_13_.jpg?300|}}

- Place servomotors on the Bottom plate, put M2*25mm screws from the bottom, then cover them with Nylon unthreaded spacers. 

{{:mmuav_12_.jpg?300|}}

- Put the top plate, then fix it with M3 Nyloc nuts.