making_the_y_axis_motor_seats
This is an old revision of the document!
Making the Y axis motor seats
0. before making the Y axis motor seats, I found the Y-axis moving square is too high to move a lot. so I take to pieces the machine, and attach the Y-axis moving square to bottom.
1. Cut the 6×3 inch square, and make a whole to the same whole of the X axis motor seats.
2. Attach the square on the stand of the Y-axis.
3. Attach the stepper motor to each of the seats.
4. Connect the control board and Power supply (upload soon)
making_the_y_axis_motor_seats.1460363438.txt.gz · Last modified: 2016/04/11 01:30 by suyonglee