This is an old revision of the document!
MM-UAV Slave arm-Servo arm-Top plate assembly
-Prepare Connector A, Servo arm, Top plate.
-Cut Weather Resistance Polyester Twine into 30cm for 12 lines, bind both side of Steel extension spring together. You are going to make 6 pairs.
- Put each pair into Carbon Fiber Tube(.315“OD). - Then, put the Twine into Connector A like ” —⇐=============⇒—– (— : twine), (<,> : Connector A) - use superglue to stick the connectors on the tube. - If the surface are rough, use sandpaper to make it smoother. It will stick easier.
- Connect Connector A to Servo-arm with superglue - Put Twine from Slave are into the connector on Servo Arm. - Pull the Twine until you feel the string touch the edge. like —-⇐===ooo>←— (— : Twine, <,> : Connector, ooo : Spring)
-Use M2.5*5mm Screws with Flat washers to anchor the twine. Then, make a thick knot near the screw.
- Make 6 pairs.
- Put Connector A into each hole on Top plate with superglue.
- Mark numbers on top plate and servo plate to connect the both correctly.