This is an old revision of the document!
Table of Contents
Pneumatic Cylinder With One Switch
Keywords: Lego, Pneumatic, Sequencing, Circuit, Cylinder
Motivation and Audience
Parts List and Sources
Part Description | Part # | Qty |
---|---|---|
Technic Axle Pin | 3749 | 6 |
Technic Pin With Friction | 4459 | 6 |
Technic Cross Block 1 x 2 (axle/pin) | 6536 | 1 |
Technic Brick 1 x 14 with holes | 32018 | 2 |
Technic Beam 3 x 3 x 0.5 | 32056 | 4 |
Technic Axle 2 Notched | 32062 | 1 |
Technic Pin Long | 32556 | 1 |
Technic Pneumatic Valve with Pegholes | 47223b | 1 |
Technic Pneumatic Cylinder | 47224c01 | 1 |
Technic Axle Joiner Inline Smooth | 59443 | 1 |
Pneumatic Hose - Various Length | 5102 | 1 |
Construction
Step 1:
Using four of the pins with friction, attach the two 1×14 bricks to each other. Attach the axle pins and the remaining two pins with friction to the outsides of the brick in the holes depicted.
Step 2:
Attach two of the 3x3x0.5 beams to one side of the bricks and use and axle pin to attach a pneumatic cylinder with the ports facing away from the bricks. Mirror the beam and axle pin structure on the opposite side as shown for stability.
Step 3:
Connect a pneumatic valve to the remaining pins with friction. With the valve switched to the left side, attach an axle joiner, a notched axle 2, and a 1×2 cross block to extend the lever to the heigh of the cylinder.
Step 4:
Using a long pin, connect the cross block to the pneumatic cylinder so that the switch may be controlled with the expansion and contraction of the cylinder.